9 | CHAPTER 2 – USING YOUR SMART TABLE
Turning off your SMART Table
If the power cable is disconnected or a power bar is turned off while the SMART Table
is turned on, the projector turns off immediately and an audible warning signifies that
the SMART Table computer is running on the uninterruptible power supply’s (UPS)
battery power. After 30 seconds, the UPS signals the computer to shut down to
protect the computer’s operating system.
If you reconnect the power cable within 30 seconds, the SMART Table returns to
normal operation, and the projector performs startup tests before the lamp starts up.
NOTES
• You can’t use the Reset switch to turn off the SMART Table.
• If you press the Reset switch for more than 30 seconds, the computer resets
but the projector turns off.
The following procedure shows the correct way to turn off your SMART Table.
To turn off your
SMART Table
1. From the SMART Table Activities menu, press .
The button moves to another corner.
2. Repeat step 1 for the number of students you’ve set up your table for.
A message appears, informing you that the
computer shutdown process will begin in 30
seconds.
TIPS
– A chime sound plays when the message first appears. This is useful in
situations where you’re away from the SMART Table and the students
accidently press .
– Press Cancel if you accidentally press .
CAUTION
• Do not disconnect the power cable or turn off the power bar until after the fans
turn off. Disconnecting the power cable or turning off the power bar at any
other time can cause projector failure and voids the warranty.
• To prevent a power surge, wait 60 seconds before plugging it back in if you
don’t have a UPS installed.