Maintaining and Troubleshooting the 4000i 51
1. Shut down the projector (see page48) and unplug it when the lamp has cooled down.
2. Open the front doors of the 4000i and disconnect all cables that are connected to the
projector, including the power cable.
3. Turn the projector adjustment knob until the projector is as low as you can get it.
4. Loosen the screws that hold the mounting bracket clamps to the inside of the 4000i.
To do this, use the 3/16" hex key from the accessory kit.
5. Remove the rear access panel (see page14).
To remove the projector from the cabinet
Projector Adjustment Knob
The projector moves this way
NOTE: For clarity, this illustration shows
the mounting bracket out of the 4000i.
Mounting Bracket Clamps