SmartPool Inc Robo-Kleen warranty Operation, Cleaning Pattern

Operation

DO NOT ENTER THE SWIMMING POOL WHILE ROBO-KLEEN ! IS IN OPERATION TO AVOID ENTANGLEMENT WITH CORD

a. Connect the cable to the power supply

b. Grasp the cleaner by a side handle and place Robo-Kleen in the pool.

c. Rock the unit from front to back and side to side, releasing trapped air, until the unit slowly sinks to the bottom of the pool.

d. Start the unit at a 90˚ angle to a wall . CAUTION: BE SURE MAIN LINE OUTLET IS PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER (GFCI) DEATH OR SERIOUS INJURY COULD OCCUR.

e. Press the top of the On/Off switch through the clear jacket on the power supply. Robo-Kleen will take an initial 10 seconds to scan the circuit board and reset the memory. After the initialization is complete, filtered water will be pumped to the top and the unit will start moving.

CAUTION: Do not operate Robo-Kleen out of the water. This may result in damage to the pump motor seals and invalidate the warranty. Optimum water temperature for the operation of Robo-Kleen is 65˚ F to 85˚ F (18˚ C to 29˚ C). Do not operate Robo-Kleen when water temperature exceeds 90˚ F (32˚ C).

Cleaning Pattern

Robo-Kleen features an exclusive Controlled Tandem design, which allows the steering wheels to move together without locking into one position. This feature, combined with interval timing in the software, which randomly changes the direction of Robo- Kleen, further enhances movement around the pool.

This eliminates the “back and forth” pattern that can occur when wheels are locked into position with fixed timing runs. Robo-Kleen’s ability to change direction easily and often results in coverage of the entire pool quickly.

Another benefit of the Controlled Tandem design is that the cleaner does not continually
move in one direction around the pool. This minimizes coiling of the cord.
For round	For oval
pools, factory	pools, remove
preset angle	limit screw for
is best.	greater angle
	of tandem
	wheels.

5