SMC Networks SMC-EZ1024DT specification

CABLES

Adjusting Existing Category 5 Cabling to Run 1000BASE-T

If your existing Category 5 installation does not meet one of the test parameters for 1000BASE-T, there are basically three measures that can be applied to try and correct the problem:

1.Replace any Category 5 patch cables with high-performance Category 5e cables.

2.Reduce the number of connectors used in the link.

3.Reconnect some of the connectors in the link.

15

Image 27

SMC Networks SMC-EZ1024DT manual Adjusting Existing Category 5 Cabling to Run 1000BASE-T

Contents

EZ Switch 10/100 Page EZ Switch 10/100 User Guide Trademarks Copyright Limited Warranty Limited Warranty Compliances FCC Class aEC Conformance Declaration Class a Industry Canada Class a Safety Compliance Iii Compliances Table of Contents Table of Contents About EZ Switch 10/100 Features and Benefits LED Front Panel LEDs Rear Panel Installing the Switch Equipment ChecklistSelecting a Site Positioning the Switch Applying PowerInstructions RJ-45 10/100 Mbps Connections Connecting to the Gigabit Uplink Port Sample Applications Installing the Switch Possible Solutions Troubleshooting Cables Cable SPECIFICATIONs 10BASE-T/100BASE-TX Pin Assignments RJ-45 Connector Pin Assignments 1000BASE-T Pin Assignments Pin MDI Signal Name MDI-X Signal Name 1000BASE-T Cable Requirements Cable Testing for Existing Category 5 Cable Adjusting Existing Category 5 Cabling to Run 1000BASE-T Network Interface Specifications Weight Specifications Page Internet