SMC Networks SMC2586W-G Changing the Radius Server Setting of Devices, Upgrading Device Firmware

Changing the RADIUS Server Setting of Devices

To change the RADIUS server settings of every selected device, carry out the Change RADIUS Servers command. You’ll be prompted to enter the Primary RADIUS server and Secondary RADIUS server.

Fig. 108 Changing RADIUS Servers dialog box.

The WPA (Wi-Fi Protected Access) standard uses IEEE 802.1x Port-Based Network Access Control and RADIUS (Remote Authentication Dial-In User Service) for advanced WLAN se-curity.

Managing Device Firmware by TFTP

To manipulate firmware and configuration files of every selected device by TFTP, carry out the various By-TFTP commands. You’ll be prompted to enter the IP address of the TFTP server (most of the time, specify the IP address of the computer on which EliteConnect Management Utility runs) and specify the folder containing or to contain the files. Refer to Section 4.3.2.4.3 for more information.

Fig. 109 TFTP Server dialog box.

Upgrading Device Firmware

Carry out the Upgrade Firmware by TFTP command.

Backing up Device Configuration

Carry out the Back up Configuration by TFTP command.

Restoring Device Configuration

Carry out the Restore Configuration by TFTP command.

Managing Device Firmware by HTTP

To manipulate firmware and configuration files of every selected device by HTTP, carry out the various By-HTTP commands. You’ll be prompted to spec- ify the folder containing or to contain the files. Refer to Section 4.3.2.4.3 for more information.

86