SMC Networks SMCD3GN Appendix B

Appendix B - Compliances

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against radio interference in a

commercial environment. This equipment can generate, use and radiate radio frequency energy and, if not

installed and used in accordance with the instructions in this manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause interference, in which case

the user, at his own expense, will be required to take whatever measures are necessary to correct the

interference. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one

of the following measures:

y Reorient or relocate the receiving antenna.

y Increase the separation between the equipment and receiver.

y Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

y Consult the dealer or an experienced radio/TV technician for help.

The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate this equipment.

IEEE 802.11b or 802.11g operation of this product in the U.S.A is firmware-limited to channels 1 through 11.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The availability of some specific channels and/or operational frequency bands are country dependent and are

firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by

the end user.

Note to CATV System Installer - This reminder is provided to call the CATV systems installer's attention to

Section 820-93 of the National Electric Code which provide guideline for proper grounding and, in particular,

specify that the Coaxial cable shield shall be connected to the grounding system of the building, as close to the

point of cable entry as practical.

SMCD3GN Wireless Cable Modem Gateway User Manual