Instructions for the Installer
2.INSTALLING THE APPLIANCE
It is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AS5601.
2.1 Positioning and levelling the appliance
The appliance is equipped with wheels and adjustable feet to simplify the positioning procedure. To use the front wheels, screw in the foot as shown here, so that the appliance rests on the front wheels. However, to allow the appliance to be moved freely it must be lifted at the back. To do this, proceed as follows:
use a 10 socket wrench to screw in the 2 hex nuts underneath the oven compartment: this raises the
appliance either to level it or to allow it to be moved around.
Once all procedures are complete, retighten the front feet and the hex nuts to set the cooker stable and level.
2.2Electrical connection
Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.
The connection to the mains shall be done conforming to the regulations in force. Check that the power line is adequately grounded. Do not use reducers, adapters or shunts. On the power line, install an omnipolar cut- off device with contact
located in an easily accessible position near the unit. The connection terminals are
located at the rear of the
appliance. For electrical connections see following diagram. To access, remove
the rear cover.
6
