![](/images/new-backgrounds/1080859/8085929x1.webp)
How to Deal with Small Problems | 13 |
If the dishwasher is to be out of use for a long period
The following precautions must be taken:
-perform two consecutive
-disconnect the plug from the mains;
-leave the door slightly open so that no unpleasant smells can form;
-turn off the water tap.
Before re-using the dishwasher after a lay-off
-
-check that no sludge or rust has been deposited in the water supply pipeline;
-allows water to flow freely from the supply tap for a few minutes;
-
The dishwasher is able to signal a series of a malfunctions by illuminating more than one light simultaneously; the key to these signals is as follows:
E1
E2
E3
E4
E5
E6
The
This alarm is only tripped if water leaks from the dishwasher. The
The dishwasher has loaded too much water and the safety level switch has been tripped.
Repeat the cycle. If the problem persists, contact the
The dishwasher is unable to heat the water.
Repeat the cycle. If the problem persists, contact the
The temperature monitoring system has failed. Switch the dishwasher OFF, switch it back on and restart the washing program. If the alarm recurs, call the
The dishwasher is unable to take in water.
Check the intake hose for kinks and ensure that the siphon is not blocked or the filters fouled.
The dishwasher is unable to discharge the water from the tank.
Check the intake hose for kinks and ensure that the siphon is not blocked or the filters fouled.
-led on
-led off
-flashing led
If an alarm occurs the appliance interrupts the program in progress and signals a fault. In case of E1, E2, E3 and E4, the washing program must be set again to continue.
In case of E5 and E6, simply open and close the door to continue (once the cause of the fault has been illuminated).