Smeg ADP8252 manual Installation cont, Stage

Installation cont... 2

Stage 1

Supplied with the appliance is a metal anti-condensation strip, this should be fixed to the underside of your worktop along the front edge (via the two outer screws). Also supplied with the appliance are two plastic skids, which should be positioned below the adjustable feet and allow the appliance to positioned easily.

The adjustable feet of the appliance allow it to be raised up to 870mm, if the space between the floor and the underside of the work surface is grater than 870mm, then the appliance should be positioned on suitable wooden spacers which should always be fixed to the floor. Always use a spirit level to make sure that the appliance is level.

After positioning the appliance, screw the feet in or out to adjust its height if necessary, and to level it until horizontal.

Proper levelling ensures that the dishwasher gives the best service.

If the appliance is installed on a carpeted floor, take care that the openings in its base are not obstructed.

Stage 2

Connect the water, drain and electrical supplies (230V 50Hz 13A). We recommend that the appliance is connected to a cold water supply.

Stage 3

Measure the width of the decor door. Align the top of the template on the rear of the door approximately 10mm above the top of the door. Using the dimensions marked on the template align the dimensions of the decor door with corresponding dimensions on the right hand side of the template. Mark through the identified position of the side fixing bracket with a bradawl. Repeat this process for the left hand side fixing bracket (ensure the left handside dimension of the template is aligned with the width of the decor door previously measured). Align the fixing bracket over the pre-marked holes and secure in position with the screws provided.