When available a drying rack could be used for such items.
•Plastic articles such as shower caps or babies’ waterproof napkin covers should not be placed in a tumble dryer.
•
If there are children in your house...
•Electrical appliances may be dangerous for the children. Keep children away from the machine when it is operating. Do not let them tamper with the machine.
•Close the loading door when you leave the area where the machine is located.
•This appliance is not intended for use by
young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely.
•Young children should be supervised to ensure that they do not play with the appliance.
2Installation
The proper location
• Install your machine in environments which have no risk of freezing and in a stable and level position.
• Do not place your machine on a long pile rug or on similar surfaces.
• Operate your machine in a well ventilated,
BMake sure that your machine is not placed on the power cable.
BPlace it at least 3 cm away from the edges of other furniture and the walls.
•A special part (Part no: 295 970 0100) replacing the top trim must be provided and installed by the Authorized Service in order to use the machine under a counter or in
a cupboard. It should never be operated without the top trim.
•Place the machine on a sound floor. If it is to be placed on top of a washing machine, the approximate weight together may reach 180 kg when they are full.
•A fitting device should be used between the two machines for use on a washing machine.
The fitting device (Part no 296 280 0100 white/ 296 280 0200 grey ) must be installed by the Authorized Service.
Levelling
In order to ensure that your machine operates more silently and
Front feet of your machine can be adjusted. Balance the
machine by adjusting the feet.
Loosen the feet by hand. Adjust them until the machine stands level and firmly.
CNever unscrew the adjustable feet from their housings.
2 plastic pieces supplied together with the Operating Instructions prevent your machine from slipping on wet and slippery surfaces. Tilt your machine to backwards t install these plastic parts. Fit the plastic parts to the front adjustable feet. Press on the plastic parts to fix them in their places. Check the balance of your machine again and readjust the adjustable feet if necessary.
Ventilation hose and connection (for products equipped with an outlet vent)
Ventilation hose assures exhausting of the air from inside the machine. Vented dryer has 1 air outlet. Stainless sheet metal or aluminum pipes can be used instead of the hose. The diameter of the pipe to be used should be minimum 10 cm.
Maximum hose and pipe lengths are given in the table below.
| Hose | Pipe |
Maximum length | 4 m | 5 m |
1 elbow 45° | ||
1 elbow 90° | ||
1 elbow 90° short |
| |
1 wall passage | ||
|
|
|
Each elbow and other passages should be subtracted from the above maximum length.
Connect the air outlet hose to the hose spacer piece by turning it
CExhaust of humid air from the dryer into the room is inconvenient. Air outlet hose must be
3- EN
