Smeg CIR34XS manual Removing the hob models with built-in control panel, Adjustment for ULPG

Instructions for the installer

5.2Removing the hob (models with built-in control panel)

1.Remove the knobs, the griddles, the burner caps, the flame caps and the two rear plugs;

2.Remove the screws “A” which fix the burner supports;

3.Raise the hob, sliding it off the ignition plugs and/or the thermocouples and the gas tap rods;

5.3Adjustment for ULPG

Check that the connection has been made as described in the “Gas connection” section.

Undo the screw “D” and push the air regulator “C” fully down. Use a spanner to remove the nozzles “B” and fit those of suitable type following the instructions given in the tables for bottled gas ULPG 2.75 kPa. The nozzle must not be tightened to a torque of over 3 Nm.

		ULPG – 2.75 kPa
	Burner	Nominal gas	Injector
		Consumption	(mm)
		(MJ/h)
Auxiliary		4.8	0.60
Semi-rapid		5.9	0.65
Rapid		8.6	0.77
Rapid large		9.5	0.85
Fish pan		9.5	0.85
Wok		15.0	1.05
14