Instructions for the Installer
8.INSTALLING THE APPLIANCE
8.1Fitting the appliance in the top
This appliance is in class 3. The procedures required below must be carried out by a skilled builder and/or joiner.
The hob can be installed on various materials, including masonry, metal, solid wood and wood finished with plastic laminates, provided the material is
Create an opening with the dimensions shown in the figure in the work surface, observing a minimum distance of 50 mm from the rear edge. The lower part of the protective cover must be fully accessible when the appliance is installed. This appliance can be installed next to walls that are higher than the work surface, as long as the distance "X" is kept, as shown in the figure, to avoid damage from overheating. Make sure that there is at least 750 mm between the hob burners and any shelving placed vertically above them.
This type of appliance also requires a cut 3 mm deep in the top with the dimensions shown in figure 2 (detail A).
The right section is indicated for laminated tops whose thickness is below 3 mm.
2)
11
