Smeg FA 120 AP Get to know your appliance, Prior to startup, Setting the operating temperature

Models: FA 120 APS FA 120 AP FA120AS

1 16
Download 16 pages 7.64 Kb
Page 10
Image 10
Electrical connections

en

en

 

 

Electrical connections

Get to know your appliance Warning

This appliance must be grounded.

Check whether the power type and voltage your region corresponds to the one stated on the rating label inside the appliance.

The electrical safety of the appliance is only assured when the grounding system in the house is installed in accordance with regulations.

When placing the appliance, do not let the power cable get stuck under it; otherwise the cable will be damaged.

Ensure that the plug remains readily accessible. Do not use a multiple adapter bar or an extension cable.

The electrical specifications of your appliance is given on the rating label located inside the appliance.

Route power cable to allow easy connection and disconnection after installation.

A contact separator should be used if the power cable is not accessible. (for built-in models)

Get to know your appliance

Prior to startup Warning

Below information about accessories are supplied only for reference. Below accessories may not be exactly same as the accessories of your appliance.

Fig. 1

1.a.) Freezing compartment & ice tray (for

Setting the operating temperature models)

b.) Frozen food compartment & ice tray (for 1 = Lowest cooling setting (Warmest setting)5 = Highest cooling setting (Coldest setting) models)

2.Interior light & Thermostat knob

3.Movable shelves

4.Defrost water collection channel - Drain tube

5.Crisper cover

6.Crisper

7.Adjustable front feet

8.Dairy compartment

9.Door shelves

10.Egg tray

11.Bottle shelf

12.Bottle gripper

13.Top trim

Do not place hot objects or any appliance that generates heat on the top trim otherwise the top trim may be damaged.

Prior to startup

Before you start operating your appliance, the following points should be re-checked for safety:

Is the appliance, standing level on the floor?

Is there sufficient space for good air circulation?

Is the interior clean? (Also see the section “Cleaning and care”)

Set the thermostat knob half way between

1 and 5 or Min. and Max.

Now connect the appliance to the mains.

The compressor is turned on; the interior light comes on when the door is opened.

Do not place foodstuff into the refrigerator until the temperature has reached the desired level.

Setting the operating temperature

(Fig. 4)

The operating temperature is regulated by the temperature control.

Warm

 

 

 

Cold

1

2

3

4

5

(Or) Min.

 

 

 

Max.

1 = Lowest cooling setting (Warmest setting)

5 = Highest cooling setting (Coldest setting)

(Or)

Min. = Lowest cooling setting (Warmest setting)
Max. = Highest cooling setting (Coldest setting)

The average temperature inside the fridge should be around +5°C.

Please choose the setting according to the desired temperature.

You can stop operation of your appliance by turning the thermostat knob to “0” position.

Please note that there will be different temperatures in the cooling area.

The coldest region is immediately above the vegetable compartment.

The interior temperature also depends on ambient temperature, the frequency with which

3

Page 10
Image 10
Smeg FA 120 AP Get to know your appliance, Prior to startup, Setting the operating temperature, Electrical connections