Smeg FAB28LAZ, FAB28LG, FAB28LNE manual Instructions for the user, Too much ice forming on back wall

Instructions for the user

PROBLEM		POSSIBLE CAUSE				PROBABLE SOLUTION
Too much ice forming on back wall	of -	Cooling	temperature	regulator	-	Turn the regulator to a lower
refrigerator section (layer of frost		device set too high (meaning				setting (1-2) to increase the
more than 1 cm thick):		lower	temperature inside the			temperature inside the appliance
		appliance);				slightly;
					-	check that the gaskets are
						providing an airtight seal;
	-	door opened often or for long			-	open the door less often and for
		periods;				shorter times;
					-	rise	in atmospheric	temperature
						and humidity;
					-	do not place hot food or drinks
						inside the refrigerator;
					-	Turn the regulator to a lower
Too much ice forming in freezer	-	inside	temperature	setting
		thermostat set on too low a				setting (1-2) to increase the
		temperature;				temperature inside the appliance
						slightly;
					-	check that the gaskets are
						providing an airtight seal: If they
						are cracked, try to soften the
						gasket by pulling it with one hand
						and sliding your closed fingers
						along the inside;
					-	open the door less often and for
						shorter times;
					-	rise	in atmospheric	temperature
						and humidity;
					-	do not place hot food or drinks
						inside the freezer;
					-	the	refrigerator is	operating
Front of cabinet hot to the touch	-
						normally. Inside the cabinet there
						is a surface cooling system
						designed to restrict the formation
						of condensation in the area where
						the door gasket closes.

32