Smeg FC35AP Description Of The Appliance, Basic Parts, Preparing The Appliance For Operation

GB

DESCRIPTION OF THE APPLIANCE, BASIC PARTS

!THE APPLIANCE ACCESSORIES LISTED BELOW MAY DIFFER FROM THE ACCESSORIES OF THE APPLIANCE YOU HAVE BOUGHT IN QUANTITY AND IN DESIGN. THIS DESCRIPTION IS ADAPTED FOR ENTIRE GROUP OF TWO–COMPARTMENTREFRIGERATOR-FREEZER COMBINATIONS.

Fig. 1

A– refrigerator compartment B – freezer compartment

1.Electricity (green light)

2.Thermostat knob

3.On / off switch for interior light

4.Interior light block

5.Adjustable height shelves

6.Glass shelf

7.Shelf for bottles

8.Fruit and vegetable boxes

9.Door trays

10.Butter and cheese compartments

11.Bottle tray

12.Bottle holder

13.Egg tray

14.Thaw water channel cleaner (red colour)

15.Container for dumplings

16.Fast-freeze section

17.Frozen products section(s)

18.Ice-cube tray

19.Thaw water channel

20.Bottom cover

21.Supports

22.Casters

23.Levelling foot

24.Condenser

25.Compressor

26.Electricity supply cord

27.Thaw water drip tray

28.Rubber sealing gasket

PREPARING THE APPLIANCE FOR OPERATION

!It is recommended to prepare the appliance for operation with a helper.

• Remove package.

• Lift the appliance away from foamed polystyrene base.

• Tear off adhesive tapes.

• When positioning the appliance in chosen location, it will move more easily into position if you lift the front a little and incline it backward, allowing it to roll on its casters 22 (fig. 1).

• Remove all red-coloured parts from the shelves (fig. 2). Tear away the red-coloured adhesive tapes from the door trays – they are intended only for the transport of the appliance.

NOTE. When you open the freezer compartment door a little red packing detail will fall out – IT IS FOR TRANSPORTATION PURPOSES ONLY.

• Suitably dispose the packaging material.

• Take two supports 21 from the bag (fig. 1, 3) and insert them into the guides at the top back part of the appliance.

!We recommend the model FC35AP to fix additionally to the wall:

• Inserts the supports into the guides at the top back part of the appliance (fig. 4).

• Mark on the wall the position of the holes in the supports.

• Drill holes in the wall and insert fixing bushings. Secure the appliance to a wall.

POSITIONING

•Place the appliance in a dry, well ventilated room.

•The appliance should not be operated in an unheated room or porch. Place the appliance away from heat sources such as kitchen stove/ oven, radiators, or direct sunlight.

•The appliance must not touch any pipes for heating, gas or water supply, or any other electrical devices.

•Do not cover the ventilation holes at the top of the appliances– it must be a good air circulation around the appliance. There should be a gap of at least 10 cm between the top

64