Smeg FC32AP, FC35AP manual Connection to the Mains, Changing the Interior Light Bulb

GB

of the appliance body and any furniture that may be above it (fig. 5). If this requirement is not followed, the appliance consumes more electrical energy and its compressor may overheat.

•If the appliance is placed in a corner, a gap of at least 1 cm must be left between the appliance body and the wall so that the freezer compartment door can be opened enough to pull out the frozen product drawer (fig. 6).

•The appliance must stand on a level surface and must not touch the wall. If necessary, regulate the height of the appliance by adjusting the levelling feet 25 (fig. 1): by turning them clockwise – the front of the appliance rises, by turning them counter clockwise – it comes down. If the appliance is tilted slightly backward

– the doors will close by themselves.

CONNECTION TO THE MAINS

WARNING! The appliance must be plugged in to an earthed electricity supply socket.

•The frequency and power of the electricity supply in your house must conform to the general data parameters of the appliance as it is shown in the table (see page 63).

•When positioning the appliance, be careful that the electrical cord isn’t squeezed in order to avoid its damage. This can cause a short circuit and a fire.

•Make sure that the plug of the electrical cord is not squeezed by the back wall of the appliance or otherwise damaged. A damaged plug can be the cause of a fire!

•When unplugging the appliance, do not touch the plug pins of the electrical cord.

CHANGING THE INTERIOR LIGHT BULB

When changing the interior light bulb (fig. 7), do the actions below in the order they are listed:

1.Unplug the appliance from the mains by pulling the plug out of the electricity supply socket.

2.Squeeze the sides of the light fixture cover

1 to unhook the cover fasteners A and pull downward. Remove the cover.

3.Replace the light bulb with the same 15 W type light bulb with the E14 lamp holder.

4.After changing the light bulb, put the cover fastener hook in place B and then press upward until its fixing in place.

5.Plug the appliance into the electricity supply socket.

CHANGING THE OPENING DIRECTION OF THE DOORS

It is recommended that changing the opening direction of the doors should be done with a helper. You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.

!When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally. Do the actions below in the order they are listed (fig. 8):

WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.

1. Remove the covers c from the body of the refrigerator and of the inner side of the door. Also remove the upper bracket 6 together with the nut and washers and the spacer under the bracket.

2. Remove the door of the refrigeration compartment. Remove the stopper 5 from the

bottom of it. On the other side of the d o o r , attach the stopper intended for doors that open on the left (you will find it in the packet).

3.Remove the middle bracket 4 together with the washers on the axle and the plastic spacer.

4.Remove the freezer compartment door 3.

5.Remove the bottom cover 1.

6.Remove the bottom bracket 2 together with the washers on the axle and the plastic spacer.

Unscrew the axle with the washers and screw it into the aperture provided on the other side.

7.Remove the bottom bracket 7 and in its place attach the other bottom bracket 2 together with the washers on the axle and the plastic spacer. Fix this bracket 7 in place of the other bracket 2.

8.Remove the covers 8 from the partition separating the refrigeration compartment from

65