Description of red indications
Red indication lamp | Indication on display | Description |
|
(if fitted on your | Causes |
| |
lights up |
| ||
machine) | Solutions |
| |
|
| ||
|
|
|
|
|
| Appliance has no or insufficient water supply. The |
|
|
| “Start/Pause” light flashes. |
|
|
| Check whether: |
|
|
| • Water tap is fully open and water supply pressure |
|
|
| is sufficient. |
|
|
| • Kinks are present in water inlet hose. |
|
|
| • Mesh filter of water supply hose is blocked (see |
|
|
| “Care and Maintenance”. |
|
|
| • Water hose is frozen up. |
|
“Water tap closed” |
| • Safety valve inspection window of your water |
|
|
| supply hose is red (provided your appliance has a |
|
|
| water supply hose as shown on picture “A” - see |
|
|
| previous chapter “Care and Maintenance”); |
|
|
| replace the hose by a new one available through |
|
|
| our |
|
After problem has been removed, restart programme by pressing “Start/Pause”. If the fault occurs again, contact our
| Waste water is not pumped out. The appliance | |
| stops in the corresponding programme step; unplug | |
| it and check whether: | |
| • Kinks are present in the drain hose. | |
| • Filter or pump is blocked (see chapter “Cleaning | |
| the Filter/ Draining Residual Water”; make sure | |
| the water has cooled before draining the | |
“Clean pump” | appliance). | |
• The drain hose is frozen up. | ||
| ||
| After problem has been removed, select and start | |
| “Drain” programme or push “Reset” button for at | |
| least 3 seconds; afterwards restart desired | |
| programme. If the fault occurs again, contact our | |
|
GB 13
