Warnings
•This product is designed for home use.
•Your washing machine is adjusted to 230V.
•If the fuse in your house is less than 16A than have a certified electrician deploy an 16A fuse.
•In case of transformer or
•Never place your machine over a car- pet covered floor. Otherwise electrical parts of your machine may overheat. This may cause malfunction of your machine.
•Make sure hot and cold taps are connected correctly. Otherwise your laundry may come out hot and torn .
•Please call certified service for a fail- ure of electric plug / cable.
•Be careful about your water hoses are not old. Do not use old / torn water hoses. This may cause stain in your laundry .
•At first use, washing must be per- formed at Cotton 90°C program with- out loading with laundry for getting your machine ready for washing.
•Performance of your washing ma- chine depends on the quality of water and hygiene compound used. If low quality and unfitting cleaning material is used the stains will be fixed. Before washing your laundry with stain keep your attention on cleaning the laundry as explained in following pages.
•This is period of keeping spare parts for your machine to operate. Because of quality control procedures there
might be little amount of water in your machine. This does not have any damage to your machine.
•Your machine is programmed for start- ing operation again when electricity is off and on afterwards. You can not press On / Off button to cancel program. Machine will go on program when electricity is on. To CANCEL the program press >Start/Pause/Cancel< button for three seconds. (See. Can- celling a program)
If “Door” led on program progress display is blinking program selection knob is middle position. In this case turn the knob and adjust it again. If the warning continues call authorized service.
•After your machine starts operation, if Start/Pause/Cancel key starts blinking than door is not locked. Open and close the door again begin washing program again.
•If the “washing” led on the program progress display is blinking either there is no water or tap is off. Check your taps. Turn your machine off and on. If the problem persists unplug your machine, turn off tap water and call authorized service.
•If program is started and program selection can not be performed your machine might be in protection mode due to infrastructure problem (voltage, water pressure, etc.) Press and hold the > Start/Pause/Cancel < button for 3 seconds in order to switch machine to factory settings.
•Most of the warnings resulting in call- ing an authorized service are due to infrastructure problems. For this rea- son applying to an Authorized Service is recommended.
5
