STARTING THE DISHWASHER

User instructions

STARTING THE DISHWASHER

After correctly carrying out all the preceding operations, to start the dishwasher simply press the START/PAUSE button (3) for a few seconds, until the start cycle acoustic device sounds.

The INFORMATION DISPLAY (8) will show the duration of the program in minutes. The duration time is only approximate, because it depends on the washing conditions (quantity of dishes, water temperature, etc.), and is also continually updated as the washing program progresses.

The INFORMATION DISPLAY (8) shows the estimated duration of the washing program.

If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, press the START/PAUSE button (3) again. This operation may negatively affective the progress of the washing cycle.

END OF CYCLE

The beeper sounds briefly and the word "End" appears on the INFORMATION DISPLAY (8) to indicate the end of the program.

Before setting a new washing program, the door must first be opened, then reclosed, or the START/PAUSE button (3) pressed to “reset” the display and stop the flashing.

To switch off the dishwasher turn the ON/OFF switch (2) anticlockwise back to the vertical position.

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

16

Page 17
Image 17
Smeg LS19-7 instruction manual User instructions, Starting The Dishwasher, End Of Cycle, Removing The Dishes