User instructions
FAULT
E5
E6
DESCRIPTION
The dishwasher fails to draw water.
Check that:
•the water supply tap is open;
•the filter in the water intake hose is not clogged;
•the water intake hose is not kinked or bent;
Turn the dishwasher off and then on again, then press the START/PAUSE button (3) again. If the problem is resolved the washing program will resume from where it was halted.
If the fault persists, call the authorised technical service centre.
The dishwasher fails to drain.
Check that:
•the flexible drain hose is not kinked or obstructed;
•the water drain pipe is not obstructed;
•the dishwasher filter is not clogged;
Turn the dishwasher off and then on again, and then press the START/PAUSE button (3) again. If the problem is resolved, the washing program will resume from where it was halted.
Otherwise, if the fault persists, call the authorised technical service centre.
In the event of error codes not included in this table, call the Technical Service Centre.
TECHNICAL DATA |
|
|
|
|
|
Width | 597 ⎟ 599 mm | |
|
|
|
Depth measured flush with the |
| Free standing: 600 mm |
outer edge of the control panel |
| |
|
|
|
Height (depending on models) |
| Free standing: from 850 mm to 870 mm |
|
| from 890 mm to 910 mm |
|
| |
|
| from 860 mm to 910 mm |
|
|
|
Capacity |
| 14 Standard place settings |
|
|
|
Water supply pressure |
| min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) |
|
|
|
Electrical characteristics |
| See rating plate |
36
