Smeg LSP1453B User instructions, Annulling A Program, HALF LOAD WASH FUNCTION on some models only

User instructions

ANNULLING A PROGRAM

To annul the program in progress, it must first be interrupted (see

“INTERRUPTION OF A PROGRAM”).

Now press buttons P1+P2 simultaneously and the first three program lights will come on.

In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “START PROGRAM”. The program will resume from the point in which it was interrupted.

In case that the tub temperature is higher than 50°C the program will start about 30 seconds later.

The washing cycle will not take place if the dishwasher door is left open or not properly closed.

HALF LOAD WASH FUNCTION (on some models only)

Pressing button ½ LOAD WASH (4) selects washing on the top basket only.

After selecting the program, proceed as follows:

•press the button ½ LOAD WASH (4) once to select the top basket (the relative light comes on);

•press the button ½ LOAD WASH (4) again to return to full load wash status (the light goes out).

The ½ LOAD wash option can be selected in all programs except the soak program.

N.B.: selecting the ½ LOAD option changes the duration of the program.

It is possible to place a cutlery basket inside the basket selected for the HALF-LOADprogram; the other basket must remain empty.

WARNING: do not load dishes and cutlery into the non-selected basket, because the water spray will only reach the selected basket.