Smeg PC45X user manual Before using the appliance, Placing, Electrical connection

1. Before using the appliance

Please read these instructions carefully. They will give you important information on the installation, operation and maintenance of the appliance.

If you throw out an old appliance, it is important to destroy the locking mechanism (not all models).

Never connect damaged appliances to the mains. All kinds of service and repair work should be carried out by authorised service men, contact your dealer for further information.

The unit is only to be used for the cooling of beverages. Bottles may burst when being cooled at very low temperatures.

Do not place inflammable liquids or gasses in the appliance owing to risk of explosion.

2. Placing

The appliance should not be exposed to direct sunlight or placed up against a heat source.

The appliance must be placed on an even, horizontal and stable surface.

When moving your appliance, do not seize hold of it under the bottom, as there might be sharp edges.

3. Electrical connection

The appliance observes the following current

EU directives:

Low Voltage 73/23 EG.

Electromagnetic Compatibility 89/336 EEC.

The appliance must be protected extra according to the power regulations in order to protect the user against dangerous electric shocks in the case of defects.

If the socket is for a three-pin plug, a three-pin plug is used and the wire with yellow/green insulation must be connected to the earth terminal (marked ).

If the socket is for a two-pin plug, a two-pin plug is used. If you assemble this one yourself, the wire with yellow/green insulation must be cut off as close as possible to the place where it enters the plug.

When changing the power cord, it must be replaced by a power cord of corresponding type.

In no circumstances cut in or remove parts from the electric circuit.

4 5