Smeg STA4645 Commissioning, Installation procedure all models, Installation Instructions

INSTALLATION INSTRUCTIONS EN

PLUG IS NOT SUITABLE FOR THE SOCKET, CALL IN A QUALIFIED ELECTRICIAN TO FIT A SUITABLE PLUG.

The plug at the end of the power cord and the corresponding socket must be of the same type and must conform to current regulations governing electrical appliances. The plug must be accessible after installation. Never remove the plug by pulling on the wire. If the power cord is damaged, have it replaced by the manufacturer or an authorized service centre.

DO NOT USE EXTENSION CORDS, ADAPTORS OR SHUNT CON- NECTIONS IN ORDER TO AVOID THE POSSIBILITY OF OVERHEAT- ING OR BURNING, WITH CONSEQUENT FIRE HAZARD.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT RE- PLACED BY THE MANUFACTURER OR AN AUTHORIZED TECHNI- CAL SERVICE CENTRE IN ORDER TO AVOID ANY RISK.

5.3 Commissioning

5.3.1Installation procedure (all models)

Clean the underneath of the worktop lying over the dishwasher door (see fi g. 5-15) and apply the steam guard, as shown in fi g. 5-16 (see fi g. 5-16 if the adhesive guard is applied; see fi g. 5-17 if the steel guard is applied). This guard protects the worktop from steam and condensation when the door of the dish- washer is opened at the end of the washing cycle.

Fig. 5-15

Rev 0.0 25