If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current progr am
immediately.
•The E5,E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
•The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
•Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
Light off Light on Light flashing
FAULT DESCRIPTION
E6
E7
E8
E9
Waterpump-out malfunction
Theappliance does not pump out the water or does
notdo so correctly.
Checkthat the drain hose is not kinked or crushed
andthat the siphon and filter are are not fouled.
Ifthe problem persists, contact the after-sales
service.
Turbineflow-regulator (for the relevant models only)
Theappliance is not able to “measure” the amount
ofwater loaded accurately. Interrupt the program
andswitch off the dishwasher.
Switchthe dishwasher back on, program it again
andstart the washing cycle. If the problem persists,
contactthe after-sales service.
Alternatewashing system malfunction
Interruptthe program and switch off the dishwasher.
Switchthe dishwasher back on, program it again
andstart the washing cycle.
Ifthe problem persists,contact the after-sales
service.
Waterintake system malfunction
Contactthe after-sales service.
22
User instructions