Smeg TLS12 manual Indication on Description

	Indication on		Description
Red indication lamp	time display
			Causes
lights up	(if fitted on your
			Solutions
	machine)
	“bdd”	Appliance stops during the programme.
	(in case your washing
	machine has no	“Drum flaps open” (the drum flaps have not been
	display: all lamps of the	closed properly).
	programme sequence	Push the “Reset” button		for at least 3 seconds
	indicator light up)
		and wait until the “Door open”			lights up. Open
		lid and close drum flaps, then select and start
		desired programme again. If fault persists, notify our
		After-Sales Service.
	from “F02” to “F35”	“Electrical module fault”
	(except “F09”)	Select and start “Drain” programme or push
		“Reset” button	for at least 3 seconds.
	“F09”	“Water level too high” (after programme
		cancellation or false operating). Switch off appliance
		and then switch it on again, select programme
		“Drain” and start within 15 sec.
	“FA”	“Waterstop fault”
“Service”		Switch off appliance, pull out mains plug and turn
		water tap off. Tilt appliance forward carefully to
		allow collected water to flow out from the bottom.
		Then:
		• Plug in the appliance again.
		• Turn the water tap on (if water immediately flows
		into the appliance without the appliance being
		started, there is a failure; turn off the tap and notify
		After-Sales Service).
		• Select and start the desired programme again.
	“Fod”	“Overfoaming”
		Too much foam interrupted the wash programme.
		• Select and start “Rinse & Spin” programme				.
		• Afterwards select and start desired programme
		again, using less detergent.
		If faults persist, unplug the appliance, turn off the
		water tap and contact our After-Sales Service (see
		next chapter).

If your washing machine has no time display, check which of the previously described situations could be the origin of the fault and follow the corresponding instructions.

GB 14