7.TECHNICAL DATA
This appliance meets the provisions of the following directives:
89/336/EEC (electromagnetic compatibility), 73/23/EEC (electrical equipment designed for use within certain voltage limits) as amended. Household appliances sold in the EU also meet 96/57/EEC (energy efficiency requirements) as amended.
The rating plate, which is placed either at the back or inside the appliance, see fig. (7) page 7, provides various technical information as well as type and serial number.
8. INSTALLATION
See drawings (1) and (2) page 6.
Install the cabinet in a dry place and so that it is not exposed to direct sunlight or any other source of heat.
Place the cabinet in a level position. This is easily achieved by adjusting the adjustable feet at the front edge of the base. The cabinet should not rest against a wall on its hinged side. When placing the cabinet on a carpet or on a wooden floor, the placing should be checked after a while to see whether the unit has „subsided“ into the soft flooring.
The cabinets can be built in or put side by side, see fig. (2b) page 5.
KF models put side by side with other models require a distance of 2 inches between the appliances.
For sufficient airflow around the cabinet it is necessary to have a 4inches high air duct right above the appliance, see fig. (2a) and (2b) or an air duct that leeds the air up over the top cupboard, see fig. (2c).
Make sufficient space for door opening as to draw the baskets out, see fig. (2e).
The dimensions for building in are noted on the drawings.
It is safest to place the earthed wall socket above the appliance and at least 2.0 m above the floor.
Any local installation rules for appliances of this kind must be observed.
During a storm the electricity supply might be cut off.
You should be aware of this when installing the appliance in weekend cottages or else- where where you would not immediately observe that the power has been cut off. Construction and details in the accessories are subject to alteration without previous notice.
If the cabinet is to be adjusted:
See drawings (1) page 6
Take hold of the front panel with both hands. Then lift up the front panel and turn out the bottom part.
Adjust the tilt of the unit
See drawings (1) page 6
by turning the adjustable feet with a 13 mm spanner.
5
