EN
11The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle.
12 Draining water from the | In the event of a power failure or a fault in the appliance, the water inside |
drum | the drum can be drained as described in paragraph 6.3 |
13The washing has not been correctly spun
14Residues of detergent on the washing
15The washing does not dry
Large items have rolled up and are not uniformly distributed inside the drum. Always wash large items together with small ones.
Many
Select the Rinse programme or brush the washing.
Check that:
-the water tap is open
|
|
| - the washing does not weight too much |
|
|
| - the drying time is suitable. |
|
|
| - sufficient drying time has been selected |
|
|
| If the machine does not dry all the same, call the Service Centre to |
|
|
| remove fabric frays from the fan and drying ducts. |
16 Washing | results | are | - Too little detergent or an unsuitable detergent may have been |
unsatisfactory |
| used. | |
- Stubborn stains were not
ERROR SIGNALS
In the event of faults, the machine will display an error code.
Error code | Problem |
Door not closed properly. Close it.
Aquastop. Contact the nearest Service Centre after disconnecting the machine from the electrical power supply and closing the water tap.
No water for washing. See point 2 on the troubleshooting table.
The water does not drain. See point 4 on the troubleshooting table.
For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing the water tap.
29
