Smooth Fitness 5.25 Motorized Treadmill

HOW TO MAINTAIN THE Smooth -5.25 TREADMILL:

Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper maintenance could cause

damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY coverage.

• Important: DO NOT use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep liquids away

and keep it out of direct sunlight.

• Inspect and tighten all parts of the treadmill regularly. Replace any damaged or worn parts immediately.

BELT ADJUSTMENT:

ALL BELT ADJUSTMENTS ARE CONSIDERED MAINTENIANCE, AND ARE THE RESPONSIBILITY OF THE END USER.

Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been adj usted properly

at the factory. However transportation, uneven flooring or other unpredicted reasons could cause the belt to shift off cen ter resulting in

the belt rubbing on the plastic side rail or end caps and possibly causing damage to the equipment. To adjust the belt back to it’s

proper position please follow the directions below:

• Walking belt has shifted to the left: First unplug the power cord from the surge protector. Using the he x key provided, turn

the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector and run

the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above

procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed this

procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping" instructions .

• Walking belt has shifted to the right: First unplug the power cord from the surge protector. Using the hex key provided,

turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector

and run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the

above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed

this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping" instructions.

• Walking belt is slipping: First unplug the power cord from the surge protector. Using the hex key provided, turn both the left

and right rear roller adjustment bolts the equal amounts, 1/2 turn in the clockwise direction. Plug the power cord back into the

surge protector and run the treadmill at 2.5 mph. You should now walk on the belt to determine if the belt is still slipping.

Repeat the above procedure until the walking belt is not slipping. The tension should be just tight enough not to slip. I f proper

tension cannot be achieved within four attempts please contact Smooth Fitness Technical Sup port. Belt centering may be

necessary once you have completed the tensioning procedure.

WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!

Right and left tension bolts are located at the rear of the treadmill.