SMOOTH 6.25E MOTORIZED TREADMILL
www.smoothfitness.co.uk
32
MOTION CONTROL OPERATION MOTION CONTROL:
Walking belt speed can be increased, decreased or stopped using the
Motion Control sensors on the handlebars. To do this follow the
instructions below:
NOTE: Photos may differ slightly from
your treadmill.
1. Press the MOTION CONTROL button on the console to
switch the motion control function on and off:
• When the LED light is ON the MOTION CONTROL is active.
• When the LED light is OFF the MOTION CONTROL is off.
2. After switching on the MOTION CONTROL wave your right hand
approximately 6 inches above the motion sensor on the right
handle bar to increase the speed. The sensor will sound one
short BEEP per scan and speed up by 0.1 MPH per BEEP.
Holding your right hand approximately 6 inches above the right
sensor constantly results in the sensor sounding one long BEEP
per second and speeding up by 0.5 MPH per second.
2. Use right sensor to speed up.
3. Wave you left hand approximately 6 inches above the motion
sensor on the left handle bar to decrease the speed. The sensor
will sound one short BEEP per scan and decrease speed by 0.1
MPH. Holding your left hand approximately 6 inches above the
left sensor constantly results in the sensor sounding one long
BEEP per second and decreasing speed by 0.5 MPH per second.
3. Use left sensor to slow down.
4. Wave both hands approximately 6 inches above both motion
sensors at the same time. The sensor will sound two short BEEP
sounds then stop the belt.
• Always switch off the motion control function by pressing
the MOTION CONTROL button on the console before
turning off the power to the treadmill.
4. Use both sensors to stop belt.