Snapper 030215-1 manual Assembly, Unpacking the Generator, Carton Contents, Install Wheel Kit

Snapper 5600W Portable Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-317-7833. If calling for assistance, please have the model, revision, and serial number from the data tag available.

Unpacking the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:

•Main unit

•Engine oil

•Operator’s manual

•Engine operator’s manual

Figure 1 — Install Wheel Kit

• Wheel kit

If any parts are missing or damaged, call the generator helpline at 1-800-317-7833.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•1/2" or 13mm wrench

•Socket wrench with a 1/2" or 13mm socket

•Pliers

•Safety goggles

Refer to Figure 1 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with air valve facing out.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

Typical Generator Shown

Hex Nut

Handle Assembly

Use existing hardware to attach left side of support leg to unit

Cap Screw

Hex Nut Axle

Cap Screw

Wheel

Flat Washer

Support Leg

E-Ring

Vibration Mount

Hex Nut

Cap Screw

6