Snapper 3250 Watt Generator
INSTALL WHEEL KIT
7.Attach the vibration mount to the mounting leg with a capscrew and lock nut.
To install wheel kit you need the following tools:
•15/16" (22mm) box, open end, or socket wrench
•Two 13mm box, open end, or socket wrenches
Install Wheel Kit as follows: (Refer to Figure 1)
Figure 1 — Installing the Wheel Kit
Capscrew |
|
|
Handle |
| Axle Stud |
|
| |
Grip |
|
|
Nut |
| Wheel |
|
| |
Nut |
| Jam Nut |
Mounting Leg | Use Existing | Washer |
| Fasteners to | |
| Retaining Pin | |
Vibration Mount | Secure Leg | |
| Capscrew |
|
1.Place bottom of generator cradle on a flat surface.
2.Place axle stud through wheel retainer on cradle frame.
3.Use 15/16” wrench to secure the axle stud to frame with
4.Install the other axle stud in the same manner.
NOTE: Be sure to install wheel with raised hub inboard.
5.Tip unit and install the wheel. Place flat washer over axle stud.
6.Retain wheel on axle stud with retaining pin. Install other wheel on remaining axle shaft the same way.
8.Remove two front nuts from vibration mount on unit with 13mm wrench. Use these nuts to retain the mounting leg.
9.Center the lifting handle on generator end of cradle. Attach the handle using two 13mm wrenches with two capscrews and two hex nuts.
BEFORE STARTING THE ENGINE
Add Engine Oil and Fuel
• Place generator on a level surface.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.
NOTE: Check oil often during engine
NOTE: The generator assembly rotates on a prelubricated and sealed ball bearing that requires no additional lubrication for the life of the bearing.
6
