Snapper 5500 Watt Generator
NOTE: Be sure to install both wheels with the air pressure valve on the outboard side.
BEFORE STARTING THE
4.Place the
NOTE: Use retaining pins instead of
5.Place one end of the needle nose pliers on the bottom of the axle and the other end of the pliers on top of the
6.Repeat step 3 through 5 to secure second wheel.
7.Remove the temporary blocks.
8.Attach the vibration mounts to the support leg with 30mm capscrews and lock nuts.
9.To aid support leg assembly, rest generator on cradle, engine end down. Remove the existing hardware from the left unit vibration mount with 13mm wrench. Use the same hardware to attach the support leg.
10.Attach the other side of the support leg with a 20mm cap screw and lock nut. Rest generator on wheels and support leg.
11.Check each fastener to ensure it is secure and the tires are inflated between
ENGINE
Add Engine Oil and Fuel
•Place generator on a level surface.
•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
NOTE: Check oil often during engine
NOTE: The generator assembly rotates on a prelubricated and sealed ball bearing that requires no additional lubrication for the life of the bearing.
7