Figure 3. Diagrams of Hitch Templates
6.Assemble the chain (D, figure 1) to the tractor as follows:
42” Blade on Group 1 and 2
On
(A).
Place one 5/ 16 washer onto the capscrew. Then place the chain on the capscrew, and then the other 5/ 16 washer:
Insert the capscrew (A, figure 4) through tractor frame. From inside the frame, install 5/ 16 locknut onto capscrew. Tighten snug only at this time. (Spring (B) will be installed in step 7.)
c . Place one washer onto capscrew. Place first link of chain (42” blade on Group 3 tractor) or second link of chain (42”/46” blade on Group 4 tractor) on capscrew.~ Install final two washers on lXp%XWV.
d. Insert capscrew (A, figure 5) through tractor frame. Tighten snug only at this time. (Spring,(B) will be installed in step 7.) From inside the frame,’ install locknut.
Figure 5. Chain Installation (Group 3 Tractor Shown)
A. Capscrew | 6. Spring |
46” Blade on Group 3
a. The chain is not used to secure spring to tractor frame. Spring is installed directly to holein tractor frame.
b. Drill a ,406 hole in the front of frame
Figure 4. Chain Installation (Group 2 Tractor
Shown)
A. Capscrew 6. Spring
42” Blade on Group 3 and 4; 46” Blade on Group 4
a. On the left hand side, remove the front hood pivot bolt.
b. Chain must be installed with the following hardware (not included in this kit):
Blade | Tractor |
| Qty | Hardware |
|
|
| Number | |
42” |
| Group 3 | 1 | Capscrew, |
| 1922130 | |||
| 1 |
| , | 3 | ,Wa.sher, 3/6 |
| 1 | 1622766 | |
|
|
| |||||||
42” |
| Group 4 |
| 1 | Capscrew, |
| 1921969 | ||
46” |
|
|
| 3 | Washer |
|
|
| 1922755 |
|
|
|
|
|
|
|
|
|
|
Figure 6. Spring Installation (Group 4 Tractor Shown)
: 7. Raise the push bar and hook up one end of spring to chain or frame as shown in figures 7A through 7F.
: Hook other end of spring to hole drilled in hitch cross
member (figure
.__ gibe).