SAFETY DECAL
I • Operate only with 540 RPM
attachmentsI
Located on PTO Shield
A S S E M B L Y
1 . Park tractor on a flat, level surface. Shut off engine, rcm”vc key. and allow all moving parts to stop.
A W A R N I N G
Iftractor has been in operation, mufiler may be hot. Use caution working around muffler or allow muffler to cool before proceeding with installation.
NOTE
The initial assembly of PTO carrier (F, figure 1) to
tract”r frame is easier with hood deck removed from tractor. To rcm”vc deck:
a. Tilt deck forward.
b. Uncouple headlight wiring harness.
c., Remove tw” spring~clips +@ two clcvis pins. d. Remove hood deck from tractor.
2.Remove PTO shield by removing spring clips and bracket. Store spring clips with bracket.
3 . Install front capscrews (i) thru carrier(F) and install washers (L), lockwasher (M), and nuts (N). Leave
hardware loose. Large washers (L),’ arc for front slotted frame holes only.
4.~ Install carrier onto tract& frame and install two rear
capscrcws (K) and hardware (M, N). Tighten snug only until PTO is installed.
5 . Apply oil or lubricant to splines of tractor PTO shaft.
6 . Remove existing bolts and nuts from PTO housing at four locations shown in figure 2. Install 5/
7. Install spacers (G) on end of caps&s (C).
8.Install woodruff key (D) onto PTO shaft.
9.Install adaptor assembly (A) to housing input shaft.
Assembly should mwc easily “vcr shaft and key. Rotate PTO adaptor so that setscrew is at top of shaft.
10.Just start PTO adaptor assembly (A) onto tractor PTO shaft. Swivel back and forth in order to align
four capscrews (C) and spacers (G) with holes in carrier (F).
11.Install washer (H) and hex n”t (I) and tighten fully. With wrench on nut (I), install jam nut (J) and tighten snug against hex nut.
12.To make sure PTO adaptor (A) is properly aligned, lift up on PTO housing (B) with one hand while sliding adaptor back and forth. There should be 3/4” - 1” play. When adaptor slides easily between both shafts, hold PTO housing in position and tighten
four capscrews (K) securing carrier (F) to tractor frame.
13.Remove setscrew from PTO adaptor (PTO housing side) and push adaptor all the way towards tractor. When Woodruff key (D) is visible (centered) in setscrew hole,
14.Remove shipping plug from PTO housing (B) and check that gear oil is level with plug. Installvent plug
(E)when oil level is correct. Use POW gear oil as ttCCCSSUy.
REMOVAL & INSTALLATION
1.After initial assembly of PTO adaptor (A), housing
(B)and carrier (F), components should be left
a s s e m b l e d . I n s t a l l a t i o n a n d r e m o v a l c a n b e
accomplished with four capscrews (K)and mounting hardware (L, M, N).
2. Install capscrews (K) only snug initially and repeat alignment procedure (step 12).
STORAGE & LUBRICATION
1. Store PTO assembly upright on frame to prevent gear oil loss.
2.Check gear oil level every season by removing oil till
plug:on front side of PTO how&$ Oil should be level with plug opening. Do not till oil to vent plug opening. Refer to figure 1.
3.Lubricate grease fittings on each side of PTO housing (B) every 25 hours of operation. Apply only
2
\
