Snapper 1694947 installation instructions Installation Instructions, Lift Lever Kit

Installation Instructions Lift Lever Kit

C

B

Mower Lift

Points

A

Figure 2. Typical Dual Point Pick-Up

A. Lift Shaft Assembly C. Lift Lever

B. Lift Rod

C

B

A

Mower Lift

Point

Figure 3. Typical Single Point Pick-Up A. Bell Crank Assembly C. Lift Lever B. Lift Rod

Note: Dual point pick-up mowers have the lift attached at two points on the mower deck. See Figure 2. Lift shaft assembly (A) is already installed on these tractors.

Do not replace with lift shaft assembly provided in kit.

Single point pick-up mowers have the lift attached at one point on the mower deck. See Figure 3.

This kit adds a lift lever for front mounted attachments.

INSTALLATION

WARNING

Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).

ALL MODELS

1.Remove mower deck as described in the Operator’s Manual.

2.Remove nuts (A, Figure 4) and capscrews (B) which hold the right rear seat deck (C) to the frame(D). Discard capscrews.

3.Install bracket (E, Figure 5) using new 5/16-18 x 1- 3/4 capscrews (B) and 5/16-18 nuts (A).

A

C

D

B

Figure 4. Capscrew Removal

A.	Nuts	C. Right Rear Seat Deck
B.	Capscrews	D. Frame

A

C

E

D

B

Figure 5. Bracket installation

A. Nuts	D. Frame
B. Capscrews	E. Bracket
C. RIght Rear Seat Deck

2