Snapper 1694947 Lift Lever Kit, Install Lift Shaft Assembly, Installation Instructions

Lift Lever Kit Installation Instructions

Install Lift Shaft Assembly

SINGLE POINT PICK-UP MODELS ONLY

1.Remove and retain spacer (E, Figure 6), bell crank assembly (F), washer (G), and nut (H). You may find installation easier to remove rod (C) and one cotter pin (A) and washer (B).

2.Remove and discard capscrew (D).

3.Mount the lift shaft assembly (A, Figure 7) to the frame using three 5/16-18 x 1 capscrews (B) and 5/16-18 flange nuts (C) as shown.

4.Install 5/16-18 x 1-1/2 capscrew (D), spacer (F), bell crank (G), washer & 5/16-18 nut (I).

5.Install rod (H), and hair pin & washer (E) if removed.

		A
C	B
D
		B	A
	E		G
	F		H

Figure 6. Rod & Bell Crank Removal

A. Hair Pin	E. Spacer
B. Washer	F. Bell Crank Assembly
C. Rod	G. Washer
D. Capscrew	H. Nut

	E
H
D
B
C
F	E
	I
G	C
B
A

Figure 7. Install Lift Shaft Assembly & Rod.

A. Lift Shaft Assembly	E. Hair Pin & Washer
B. Capscrews, Hex	F. Spacer
5/16-18 x 1	G. Bell Crank
C. Flange Nuts, 5/16-18	H. Rod
D. Capscrew, Hex	I. Washer & Nut, 5/16-18

35/16-18 x 1-1/2