Snapper 1695064 manual Initial Counter Balance & Weight Carrier Installation

Initial Counter Balance & Weight

Carrier Installation

	B
	D	A. Rear Deck Lift Lever
		B. Trunnion (Existing)
A	C	C. Hair Pin (Existing)
	E	D. Spacer, Spring (New)
		E. Spring (New)
L	F	F. Washer (New)
		G. Plate, Spring Support (New)
M	I	H. Spacer (Existing)
	J	I. Eyebolt (Existing)
		J. Washer (Existing)
	G	K. Capscrew (Existing)
		L. Nut (Existing)
	H	M. Mower Deck

		K
Figure 1. Counter Balance Installation
COUNTER BALANCE & WEIGHT		C
			A
CARRIER INSTALLATION
Counter Balance Installation		C
1.	Remove hair pin (C, Figure 1) from trunnion (B).	A	B
	Remove trunnion (B) from rear deck lift lever (A).
	Mark or measure trunnion position on rear deck lift
	lever. Remove trunnion (B) from eyebolt (I).
2.	Remove capscrew (K), washer (J), eyebolt (I), spacer	F	B
	(H) and nut (L) from mower deck (M).
3.	Thread eyebolt (I) through plate (G) as shown.		E
4.	Attach capscrew (K), washer (J), eyebolt (I), spacer	E	D
	(H), to mower deck (M) securing with nut (L).
5.	Slide washer (F), spring (E), and spacer (D) onto
	eyebolt (I) as shown.	Figure 2. Front Weight Carrier Installation
6.	Install trunnion (B) onto eyebolt (I) to position of mea-
		A. Holes	D. Rod
	surement or mark from step 1.	B. Capscrews,	E. Clips, Safety
7.	Install trunnion (B) into rear deck lift lever (A) secure	1/2-13 x 1-1/4	F. Carrier, Weight
		C. Locknut, 1/2-13
	with hair pin (C). Check deck leveling as described in
	Operators Manual and make necessary adjustments.

Front Weight Carrier Installation

1.Install carrier (F) as shown securing with 1/2-13 x 1-1/4 capscrews (B), and 1/2-13 locknuts (C).

2.Rod (D) and safety clip (E) are used to secure required weights.

10