Initial Turbo Installation
E | B | D |
| A |
|
|
| C |
Figure 9. Install Idler Assembly |
|
A. Idler Assembly. | D. Locknuts, |
B. Belt Guide | E. Taptite Screws |
C. Capscrew, |
|
Install Idler Assembly & Belt Guider
Torque to | E |
| D |
Original | F |
Pulley and | C |
Spacer | |
| B |
| A |
Figure 10. Install Turbo Drive Pulley
A. Original Pulley & Spacer | D. Spring Washer (New) |
B. Spacer, W/Groove(New) | E. Sleeve Nut (New |
C. Pulley (New) | F. Spacer (New) |
1.See Figure 9. Remove and discard the two taptite screws from locations (E).
2.Insert two
3.Mount the idler pulley assembly (A) to the deck using the two
Install Turbo Drive Pulley
1.See Figure 10. Remove the arbor drive belt from the right side arbor pulley.
2.Remove and discard the flange nut and spring wash- ers securing the arbor pulley and spacer (A). Retain the pulley and spacer (A).
3.Install the new spacers (B&F), turbo drive pulley (C), spring washer (D), and sleeve nut (E). Be sure the notches in the pulleys and spacers are aligned. Install the spring washer concave side down. Torque the sleeve nut to
4.Reinstall the arbor drive belt on the lower pulley.
Install Anchor Bracket
1.See Figure 12. If not already done, assemble the anchor bracket and related components as shown in Figure 11.
2.Attach the anchor bracket assembly (B, Figure 12) to the mower deck using
NOTE: The deflector latch MUST secure the deflector in a down
C | D | G |
B |
| F |
H |
| E |
A |
| |
|
| |
Figure 11. Anchor Bracket Assembly | ||
A. Anchor Bracket |
| E. Nut, Hex, 5/16 |
B. Lockwasher, 5/16, Large F. Wing Nut, 5/16 | ||
C. Latch, Spring |
| G. Locknut, 5/16 |
D. Lockwasher, 5/16, Small H. Capscrew,
B | C |
|
A |
Figure 12. Anchor Bracket Installation
A. Capscrews, 5/16-18 x 1 C. Locknut, 5/16-18 B. Anchor Bracket
7
