38 www.simplicitymfg.com | www.snapper.com
Troubleshooting
ROLLER BAR LEVELING (SELECT MODELS)
The rollers on this Zero Turn unit are not intended to
ride on the ground. DO NOT adjust rollers to ride on
the ground.Rollers riding on the ground will damage
turf and/or unit.
1. First level the mower deck using the procedure
found in MOWERDECK LEVELING.
2. With the mower installed, place the rider on a
smooth, level surface such as a concrete floor.
Turn the front wheels so they are straight.
3. Place the mower cutting height pin in the 4th hole
from the bottom (C, Figure 39).
4. Measure the distance between the outside ends of
the roller bar and the ground.If there is more than
1/8”(3mm) difference between the measurements
on each side, proceed to step 5.
5. Locate the roller bar leveling eccentric and
locknuts (A, Figure 42). Loosen the locknut and
turn the eccentric to raise or lower a side. When
the correct level is achieved, hold the eccentric
with a wrench and tighten the locknut. Repeat
step 4 if necessary.
Figure 41. Roller Bar Leveling
A. Eccentric and Locknut
A
MOWER BELT REPLACEMENT
1. Park the rider on a smooth, level surface such as a
concrete floor. Disengage the PTO, engage the
parking brake, turn off the engine, and remove the
ignition key.
2. Raise the mower deck to transport position. Pull
the lever (A, Figure 42) towards the rear of the
machine to release tension on the mower belt.
Secure the lever in the guard notch (B).
3. Remove the old drive belt and install the new one
as shown in Figure 43. Note that the back of the
drive belt must ride against the back-side idler
pulleys (B). Use the belt tension lever (A, Figure
42) to release tension on the idler pulley for
installation.

To avoid damaging belts,DO NOT

PRY BELTS OVER PULLEYS.

Figure 43. Mower Belt Routing
A. Arbor Pulleys
B. Back-Side Idler Pulleys
C. PTO Pulley
D. Belt Tension Release Lever
A
A
A
C
D
B
Figure 42. Release Belt Tension
A. Belt Tension Release Lever
B. Guard Notch
A
B
Troubleshooting, Adjustments, & Service