Operating the Tractor

Attaching a Trailer

The maximum weight of a towed trailer should be less than 800 lbs (363 kg). Secure the trailer with an appro- priately sized clevis pin (A, Figure 23) and clip (B).

Excessive towed loads can cause loss of traction and loss of control on slopes. Reduce towed weight when operating on slopes. The surface being driven on greatly impacts traction and stability. Wet or slippery surfaces can greatly reduce traction and the ability to stop or turn. Carefully evaluate the surface conditions before operat- ing the tractor and trailer, and never operate on slopes greater than 10°. See SLOPE OPERATION and TOWED EQUIPMENT in the safety section of this manu- al for additional safety information.

Storage

WARNING

Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion.

Fuel vapor is also toxic to humans and animals.

Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps:

•Disengage the PTO, set the parking brake, and remove the key.

•Perform engine maintenance and storage measures listed in the engine owner’s manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed struc- ture - see warning).

•Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If the battery is left in the unit, disconnect the nega- tive cable.

Before starting the unit after it has been stored:

•Check all fluid levels. Check all maintenance items.

•Perform all recommended checks and procedures found in the engine owner’s manual.

•Allow the engine to warm up for several minutes before use.

A

 

B

 

800

Lbs.

(363kg)

3'4"

10˚

(1m)

 

20' (6m)

 

Figure 23. Trailer Weight Recommendations

A.Clevis Pin

B.Clip

12 Volt Power Outlet

CAUTION

Avoid Injury. Safe operation requires your full attention. Do not wear radio or music headphones while operating machine.

The 12-volt accessory outlet is located in the left side pod. It can be used to power small electronic devices. The accessory must be rated at 14 amps or less.

Note: Operating a 12-volt accessory, especially with the engine at idle, may cause battery discharge. When not using the accessory outlet it must be covered with the rubber plug to prevent moisture from causing a short cir- cuit. Entrance of water into outlet can cause a short cir- cuit.

24

Page 25 Page 27
Page 26
Image 26
Snapper STGT2754D, 2690627, GT 600 Series manual Attaching a Trailer, Storage, Volt Power Outlet
Page 25 Page 27

2690627, STGT2754D, GT 600 Series specifications

The Snapper GT 600 Series, specifically the STGT2754D model, is a standout in the realm of high-performance lawn care equipment. Designed for both efficiency and durability, this mower is perfect for homeowners with medium to large lawns who seek both power and reliability in their outdoor equipment.

One of the key features of the Snapper GT 600 Series is its robust 27 horsepower engine. This powerful engine enables the mower to tackle tough terrains and thick grass effortlessly. The innovative design includes a cutting deck size of 54 inches, which allows for a wide cutting path that reduces mowing time and enhances productivity. The adjustable cutting height provides multiple settings, accommodating various grass types and preferences, from a low, manicured look to a higher cut for more rugged areas.

The Snapper GT 600 Series incorporates advanced engineering with its high-performance transmission system. This system provides smooth acceleration and effortless steering, ensuring that maneuvering around obstacles like trees and flower beds is a breeze. The quick-turn radius enhances this maneuverability, allowing the operator to navigate tight spaces with confidence.

Technology plays a significant role in the GT 600 Series. The mower boasts an intuitive dashboard equipped with user-friendly controls, including easy-to-read displays for speed and fuel level. This feature not only enhances user experience but also promotes efficiency by allowing the operator to monitor essential metrics in real time.

Another notable characteristic of the STGT2754D is its durability. Built with a robust steel frame and heavy-duty components, this mower is designed to withstand the rigors of regular use. The weather-resistant materials ensure longevity and reliability under various conditions, making it a wise investment for any lawn care enthusiast.

Moreover, the Snapper GT 600 Series prioritizes user comfort. The high-back seat is designed for extended use, providing ample support and reducing fatigue during longer mowing sessions. Additionally, the vibration dampening system minimizes discomfort, enhancing overall control and driving experience.

In conclusion, the Snapper GT 600 Series STGT2754D is a powerful, technologically advanced lawn mower designed for efficiency and ease of use. Its combination of a robust engine, wide cutting deck, advanced transmission system, and user-friendly features make it a top choice for homeowners seeking to achieve a pristine lawn with minimal effort. Whether you're a seasoned gardener or a novice, the Snapper GT 600 Series promises to deliver performance and reliability for all your lawn care needs.
Top Page Image Contents