Snapper 30216 manual Install Wheel Kit, Refer to and install the wheel kit as follows

Snapper 6200W Portable Generator

Install Wheel Kit

The wheel kit is designed to greatly improve the portability of your generator.

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install this wheel kit:

•1/2" or 13mm socket wrench

•1/2" or 13mm open end wrench

•Pliers

•Safety glasses

Refer to Figure 2 and install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Slide a wheel over the axle.

NOTE: Be sure to install both wheels with the air pressure valve on the outboard side.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

• Always wear eye protection when installing/removing e-rings.

6.Repeat step 3 thru 5 to secure second wheel.

7.Tip generator so that engine side is down.

8.Attach the vibration mounts to the support leg with 1/4-20 x 1” capscrews and 1/4-20 lock nuts.

9.Remove the existing locknut from the left unit vibration mount with 13mm wrench. Use the same locknut to attach the support leg.

10.Attach the other side of the support leg with a M8 x 20 mm capscrew and M8 lock nut.

11.Return generator to normal operating position (resting on wheels and support leg).

12.Check each fastener to ensure it is secure and the tires are inflated between 15-40 PSI.

Figure 2 — Install Wheel Kit

	Wheel
Use existing hardware	Flat Washer
to attach left side of
support leg to unit	Axle
Hex Nut
Support Leg	Capscrew
	E-Ring
Vibration Mount
Capscrew	Hex Nut
	7