Maintenance
Regular Maintenance
Sharpening the Mower Blade
CAUTION
Avoid injury! Mower blades are sharp.
•Always wear gloves when handling the mower blades.
•Always wear safety eye protection when grinding.
1.Sharpen the mower blades with grinder, hand file, or electric blade sharpener.
2.Sharpen the mower blade by removing an equal amount of material from each end of the mower blade.
3.Keep the original bevel (A, Figure 26) when grinding. DO NOT change the mower blade bevel.
4.The mower blade should have a maximum 1/64” (0,40 mm) cutting edge (B) or less.
5.Balance the mower blades before installing.
Balancing the Mower Blades
CAUTION
Avoid injury! Keep mower blades balanced.
•An unbalanced mower blade can create excessive vibration and damage the unit or cause mower blade failure.
1.Clean the mower blade to remove any dried grass or other debris.
2.See Figure 27. Put the mower blade on a nail in a vise and turn the mower blade to the horizontal position.
3.Check the balance of the mower blade. If either end of the mower blade moves downward, sharpen the heavy end until the mower blade is balanced. See Sharpening the Mower Blades for proper sharpening instructions.
4.Repeat the process until the mower blade remains in the horizontal position.
Reinstalling the Mower Blades
1.Reinstall each mower blade with the air lifts pointing up towards the mower deck as shown in Figure 28. Secure with the mower blade mounting bolt and flat washer (A & B, Figure 28) and torque to 70 ft. lbs (94 Nm).
2.If there are no flats on the spindle shaft, wedge a wooden block between the mower blade and the mower deck housing to keep the mower blade from turning.
A |
B |
Figure 26. Sharpening the Mower Blade
A.Mower Blade Bevel
B.Mower Blade Cutting Edge
A |
Figure 27. Balancing the Mower Blade
A. Nail
B |
A |
D |
Figure 28. Tightening the Mower Blade for Installation
A.Mower Blade Mounting Bolt
B.Flat Washer
C.Mower Blade Air Lift (Points Up For Installation)
D.4 X 4 Wooden Block
28 | www.SnapperPro.com |
