Regular Maintenance
1.Park the tractor on a smooth, level surface such as a concrete floor. Disengage the PTO, engage the parking brake, turn off the engine, and remove the ignition key.
2.Remove the PTO drive belt (see MOWER BELT REPLACEMENT for removal instructions).
WARNING
STORED ENERGY DEVICE: Improper release of the belt tension spring can result in personal injury.
Use extreme caution when removing this spring.3.Loosen and remove the crankshaft bolt (C, Figure 43) and the PTO clutch (B) from the engine crankshaft.
4.Loosen the nut on the spring anchor eyebolt (G, Figure 44) to release the majority of the belt tension. Use caution and remove the nut to completely release the tension.
5.Remove the old belt and replace it with the new one. Make sure the
6.Reinstall the spring anchor eyebolt (G) into the anchor tab and loosely fasten the nut. Adjust the anchor eyebolt until a measurement of
7.Reinstall the PTO clutch to the engine crankshaft and secure with the crankshaft bolt. Tighten the crankshaft bolt to 65 ft. lbs (88 Nm).
NOTE: Make sure that the slot in the PTO clutch lines up with the PTO clutch mounting tab (A, Figure 43) underneath the engine deck.
8. Reinstall the PTO drive belt.
| Reproduction | B | |||
|
| for |
| H |
|
|
|
|
|
| |
| Not |
| E |
| D |
|
|
|
| A | |
|
|
|
|
| |
A |
|
| C |
| C |
|
|
|
|
| |
|
|
|
|
| F |
|
|
|
|
| G |
|
|
|
| ||
B |
| (14.92 cm) |
|
| |
|
|
|
|
| |
C |
|
|
|
|
|
Figure 43. Removing the PTO Clutch |
|
|
|
| |
A. PTO Clutch Mounting Tab |
| Figure 44. Hydraulic Pump Drive Belt Replacement | |||
B. PTO Clutch |
| ||||
| A. Pump Drive Belt |
| |||
C. Crankshaft Bolt |
|
| |||
| B. Crankshaft Pulley |
| |||
|
|
| |||
|
| C. Pump Pulley |
| ||
|
| D. Idler Pulley |
| ||
|
| E. Idler Arm |
|
| |
|
| F. Spring |
|
| |
|
| G. Spring Anchor Eyebolt |
| ||
|
| H. Stationary Idler Pulley |
| ||
34 | www.SnapperPro.com |