Regular Maintenance
Deck Rod Timing Adjustment - 72”
Models
1. Park the machine on a flat, level surface. Disengage the PTO, engage the parking brake, turn off the engine, and remove the ignition key. Rear tires must be inflated to 15 psi (1,03 bar).
2. To check lift rod timing measure and record the distance between the lift pivots and the rod pivots. Repeat for other side of the unit. See Figure 42.
3. If the measurements for the rods are equal, no further adjustment is required. If measurements are not equal (greater than 1/8” (3,17 mm) difference) adjustment is required, continue with step #4.
4. | Lock the deck lift pedal in the 6” (15,2 cm) position. |
| Figure 42. | Check Lift Rod Timing | ||
| Remove the cutting height adjustment pin and lower the |
|
|
| ||
| mower deck. |
|
|
|
|
|
5. | To ensure that the deck is in the lowest position, push |
|
|
| ||
| the pedal by hand towards the rear of the unit and install |
|
| |||
| the height adjustment pin in the 3” (7,6 cm) position to |
|
|
| ||
| hold in place. | Reproduction | ||||
6. |
| |||||
Block up the mower deck until all hanger chains are | for |
| ||||
| slack. Refer to Figure 43. |
|
|
| ||
|
|
|
|
|
| |
7. | See Figure 44. To adjust the lift rod, loosen the jam |
|
|
|
| |
| nut on the front clevis then remove the 1/2” clevis pin |
|
|
| ||
|
| Not |
|
| ||
| fastening the clevis to the lift pivot arm. Turn he clevis |
|
|
| ||
| clockwise to shorten the distance between the rod pivo s |
|
| |||
| or |
| Fig re 43. | 2 x 4 Locations | ||
| the rod pivots. Reinstall the clevis on the lift piv t arm |
|
|
| ||
| and secure with the 1/2” clevis pin previously rem | ved. |
|
|
| |
| Tighten the jam nut against the clevis. |
|
|
|
| |
8. | Remove the blocks from under the mower deck. |
|
|
|
| |
9. | Remove the cutting height adjustment pin from in f | nt |
|
|
| |
| of the deck lift pedal arm. Lift mower deck and reinstall |
|
|
| ||
| adjustment pin in desired mowing height. |
|
|
|
| |
|
|
|
|
| Figure 44. Adjust Lift Rod Timing |
35