Not for
Reproduction
25
Maintenance
Figure 24. Checking Transmission Oil Level
A. Transmission Oil Reservoirs
B. “FULL COLD” mark
A
B
Check / Fill Transmission Oil
Oil Type: 20W-50 conventional detergent motor oil.
1. Check the oil level when the unit is cold. Locate
the transmission oil reservoirs (A, Figure 24)
located on the seat support plate. The oil should
be up to the “FULL COLD” mark (B). If the oil is
below this level, proceed to step 2.
2. Before removing the reservoir caps, make sure
the area around the reservoir cap and fill neck of
the reservoir is free of dust, dirt, or other debris.
Remove the reservoir cap.
3. Add oil up to the “FULL COLD” mark (B).
4. Reinstall the reservoir caps.
Transmission Oil Filter Change
Change Interval: Every 200 Hours
Replacement Filter Number: 5101026X1
1. Locate the transmission oil filters (A, Figure
25) underneath the rear of the machine on the
transmissions.
2. Remove the three 1/4” filter guard screws (C) and
the filter guard (B).
3. Clean the area around the filter base and remove
the filter.
4. Apply a film of new oil to the gasket of the new
replacement filter. After the oil has drained,
thread the new filter onto the filter base until the
gasket makes contact, then tighten 3/4 of a turn
more.
5. Reinstall the filter guard with the three 1/4” filter
guard screws
6. Using a hex bit swivel socket or a modified
allen wrench remove the top port plug from the
transmissions.
7. Remove the transmission reservoir cap and fill
with oil until oil appears at the bottom of the
transmission’s top port (approximately 2 qts
(1,89L).
8. Reinstall the top port plug and tighten to 15 ft lbs
(20,38 Nm).
9. Continue to add oil to the transmission oil
reservoirs until the oil level reaches the “FULL
COLD” mark. Reinstall the oil reservoir cap.
10. Repeat this process for the other side of the
machine.
11. Run the unit for several minutes and check the
transmission oil level.
IMPORTANT NOTE: Use caution after changing
the filter; air in the hydraulic system may affect the
responsiveness of the ground speed control levers.
Repeat step 11 until the air is out of the system.
Figure 25. Transmission (Left Side Shown.)
A. Transmission Oil Filter
B. Filter Guard
C. 1/4” Filter Guard Screws
D. Top Port Plug
A
B
C
D