![](/images/new-backgrounds/1175729/1757295x1.webp)
TRACTOR MODEL SHOWN (DEFLECTOR REMOVED)
RETAINING
RIDGES
ENGAGEMENT
LUGS
POSITION ADAPTER
FORWARD OFADAPTER ENGAGEMENT LUGS
FIGURE 5B
TRACTOR MODEL SHOWN (DEFLECTOR REMOVED)
BOLT
WASHER
WING NUT
FIGURE 5C
STEP 6: Adapter Kit Installation (Tractors only). Install Adapter Kit
BUMPER
KIT #6-1334 SHOWN INSTALLED
ON LT LAWN TRACTOR
FIGURE 6
STEP 7: DUST SKIRT TO FRAME INSTALLATION Punch out or tear out the center portion of the reinforcement patches (There are two large ovals and five small round patches) on dust skirt. Insert the legs of the frame through the two larger holes in the skirt. Position the five patches over the studs on the frame (make sure square shield patch on skirt is installed on muffler side). See Figure 7. Then push the frame down over the bumpers. NOTE: Skirt should be on outside of frame and should pass between frame and bumpers. Insert pins in upper holes in bracket to lock frame in place. Install clevis pins through holes and secure with hair pins. Refer to exploded illustration on page 6.
LEGS OF FRAME ARE THROUGH LARGE OVAL SLOTS
| POSITION |
REAR OF RIDER | SKIRT OVER |
STUDS |
FIGURE 7
STEP 8: Install the grass catcher latch (item 13) on the outside of frame using the
14)on outside of frame and with the
FACETED
WASHER
STUD
CONTAINER
TOP
FIGURE 8
3