#6-0943 SINGLE BAG GRASS CATCHER KIT for
28" & 33" REAR ENGINE RIDERS AND LAWN TRACTORS
This Single Bag Grass Catcher Kit fits SNAPPER 28” & 33” Rear Engine Riders. It also fits SNAPPER Tractors provided the tractor is equipped with the rear mount adapter kit & has 33" mower. Kit
WARNING
Before attempting any adjustments, maintenance, service, or repairs, stop engine and blade, always remove key from ignition switch, remove spark plug wire(s) and secure wire(s) away from spark plug(s). Engine, muffler and surrounding areas are extremely hot. Allow components to cool down before installing kit. Load Carrier Kit
STEP 1: BUMPER REINFORCEMENT BRACKET & MUFFLER GUARD INSTALLATION (USED ON REAR ENGINE RIDERS ONLY)
Remove the two screws securing the right side rear bumper. Remove screw from right rear panel. Install bumper reinforcement bracket and secure to right rear panel, secure with screw. See Figure 1. Place muffler shield against bumper reinforcement bracket and right side rear bumper, install screws. Tighten securely. See Figure 1.
REAR ENGINE
RIDER SHOWN
RIGHT SIDE
REAR BUMPER
BUMPER
REINFORCEMENT
MUFFLER
SHIELD
FIGURE 1
STEP 2: REMOVAL OF DEFLECTOR (Tractors Only) A. Remove the hinge nut, spring and hinge pin from deflector. Remove deflector. Remove wing nut, flat washer, bolt retainer and bolt from deck. Save for future use when not bagging grass. See Figure 2A.
33” DECK
SPRING
HINGE
PIN
HINGE
NUT
| DEFLECTOR |
| FLAT WASHER |
BOLT | WING NUT |
| BOLT RETAINER |
| (DISCARD) |
FIGURE 2A
Note: The deflector on rear engine riders need not be removed (except on some older models). Lift the deflector up and out of the way before installing adapter.
B. ADAPTER INSTALLATION
Install the previously removed bolt into the hole in the center of the discharge opening. See Figure 2B.
33” DECK
INSTALL BOLT
FIGURE 2B
INSTRUCTION No.