Snapper 6200 ASSEMBLY, ELECTRIC START

Snapper 6200W Portable Generator

6

ASSEMBLY

Your generator requires some assembly and is ready for

use after it has been properly serviced with the

recommended oil and fuel.

If you have any problems with the assembly of your

generator,please call the generator helpline at

1-800-317-7833.If calling for assistance ,please have the

model,revision, and serial number from the data tag available.

Unpacking the Generator

1. Set the carton on a rigid flat surface.

2. Remove everything from carton except generator.

3. Open carton completely by cutting each corner from

top to bottom.

4. Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:

• Main unit

• Engine oil

• Operator’s manual

• Engine operator’s manual

• Battery float charger

• Wheel kit

If any parts are missing or damaged,call the generator

helpline at 1-800-317-7833.

ELECTRIC START

Your unit is equipped with electric start capability but can

be started manually.If you choose not to use the electric

start feature, you do not need to connect the negative

battery cable.

Check Battery / Attach Negative

Battery Wire

The sealed battery on the generator is fully charged and

pre–installed except for the negative (black) battery cable.

To install:

1. Cut off tie wrap securing loose end of negative (black)

cable.

2. Remove screw,lock washer and flat washer on

negative battery terminal.

3. Slide lock washer,flat washer and negative battery

cable over screw (Figure 1).

4. Reattach screw to negative battery terminal and

tighten.

5. Verify that connections to battery and generator are

tight and secure.

Figure 1 — Negative Battery Connection

Negative

Battery Cable

Screw

Flat Washer

Lock Washer Positive

Battery Cable

Contents

Main Operators Manual / Manual del Operario 6200 Watt Generator TABLE OF CONTENTS EQUIPMENT DESCRIPTION Hazard Symbols and Meanings CAUTION! SAVE THESE INSTRUCTIONS Page Page KNOW YOUR GENERATOR ASSEMBLY Unpacking the Generator Carton Contents ELECTRIC START Check Battery / Attach Negative Battery Wire Install Wheel Kit BEFORE STARTING THE ENGINE Add Engine Oil Add Fuel USING THE GENERATOR System Ground Connecting to a Buildings Electrical System Generator Location OPERATING THE GENERATOR Starting the Engine Connecting Electrical Loads Stopping the Engine RECEPTACLES NEMA L14-30 120/240 Volt AC, 30 Amp, Locking Receptacle 120 Volt AC, 20 Amp, Duplex Receptacles BATTERY CHARGER DON'T OVERLOAD GENERATOR Capacity Power Management SPECIFICATIONS GENERAL MAINTENANCE RECOMMENDATIONS Engine Maintenance Generator Maintenance Battery Maintenance STORAGE Generator Storage Engine Storage Other Storage Tips TROUBLESHOOTING Problem Cause Correction Page Page TABLA DE CONTENIDOS DESCRIPCIN DEL EQUIPO Smbolos de Peligro y Significados PRECAUCIN! CONSERVE ESTAS INSTRUCCIONES Page Generador Porttil de 6200W Snapper CONOZCA SU GENERADOR MONTAJE Desembalaje del Generador Contenido de la Caja ARRANQUE ELCTRICO Verifique la Batera / Conecte el Cable Negativo de la Batera Instale el Juego de Ruedas ANTES DE DARLE ARRANQUE AL MOTOR Agregar Aceite al Motor Agregue Combustible USO DEL GENERADOR Tierra del Sistema Conexin al Sistema Elctrico de un Edificio Ubicacin del Generador OPERANDO EL GENERADOR Encienda el Motor Conexion De Cargas Electricas Parado Del Motor RECEPTCULOS NEMA L14-30 120/240 Voltios AC, 30 Amp, Receptculo de Seguridad 120 Volt AC, 20 Amp, Receptculos Dobles CARGADOR DE BATERA NO SOBRECARGUE GENERADOR Capacidad Control de la Energa ESPECIFICACIONES RECOMENDACIONES GENERALES DE MANTENIMIENTO Mantenimiento del Motor Mantenimiento del Generador Mantenimiento de la Batera ALMACENAMIENTO Almacenando el Generador Almacenando el Motor Otras Sugerencias Para el Almacenando DIAGNOSITICOS DE AVERAS Problemo Accion Causa POLTICA PARA EL PROPIETARIO DE EQUIPOS SNAPPER Efectiva desde el 1 ro de Agosto,2004 PERIODO DE GARANTA* BRIGGS & STRATTON POWER PRODUCTS GROUP,LLC JEFFERSON,WISCONSIN, U.S.A.