Snapper 7-4172 manual B. Remove driven disc spring from driven disc, Figure

STEP 8: Driven disc to drive disc adjustment is set up at the factory. In case driven disc may need adjustment, proceed as follows:

A. Place speed control rod in the number six speed position. See Figure 7.

	SIXTH SPEED
MOVE GROUND SPEED	POSITION
CONTROL TO SIX SPEED
POSITION

C. Slide driven disc assembly over until 1/8” from outside edge of drive disc. Maintaining the 1/8” measurement, remove any looseness from the linkage. This can be done by holding the transfer rod and applying pressure to the left (as viewed from operators position), then retighten the connector hex nut securely. See Figure 9. Move shift rod to the number one speed position, then back to the number six speed position. Recheck the 1/8” measurement described previously. Reinstall driven disc spring to driven disc assembly.

SIXTH

		1/8” MEASUREMENT
FIRST SPEED	SLIDE DRIVEN	TO OUTSIDE EDGE
		OF DRIVE DISC
POSITION	DISC ASSEMBLY
	TOWARD	DRIVE
	OUTSIDE EDGE
		DISC
FIRST	CONNECTOR

TRANSFER

ROD	OUTSIDE
	EDGE
FIGURE 7	CONNECTOR
B. Remove driven disc spring from driven disc	HEX NUT

assembly as shown. Loosen connector hex-nut. See	FIGURE 9
Figure 8.
	STEP 9: Make sure all nuts and bolts are tight.
DRIVEN DISC
ASSEMBLY
DRIVE DISC

DRIVEN

DISC

SPRING

TRANSFER

RODCONNECTOR HEX

NUT

CONNECTOR

FIGURE 8

3