SET-UP INSTRUCTIONS & PRE-OPERATION CHECKLIST
For SNAPPER “W” SERIES REAR ENGINE RIDERS
INTRODUCTION: The SNAPPER “W” Series Rear Engine Riders are shipped fully assembled and require minimal
BATTERY ACTIVATION and INSTALLATION
Snapper riders with a model prefix “W” are supplied with wet batteries and do not require the addition of electrolyte. All batteries require a slow charge before being placed into service.
1.BATTERY REMOVAL
A.Remove battery cover by pulling each side away from ratchet fasteners. See Figure 1.
B.Remove the hair pin and swivel from the deck support to allow clearance for battery removal.
C.Remove battery from battery compartment.
PULL COVER AWAY
FROM RATCHET
FASTENERS ON
BOTH SIDES
FIGURE 1
WARNING
The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected areas immediately after having eye or skin contact with electrolyte (acid). Battery acid is corrosive. Rinse empty acid containers with water and mutilate before discarding. If acid is spilled on battery, bench, or clothing, etc., Flush with clear water and neutralize with baking soda. DO NOT attempt to charge battery while installed on the RIDER. DO NOT use “BOOST” chargers on the battery. DO NOT OVER FILL!
2.BATTERY CHARGING
A.With all cell caps removed, connect an automotive type battery charger to battery terminals; RED to positive (+) and BLACK to negative
B.Slow charge at 2 to 6 amps for 30 minutes.
C.After charging, check level of electrolyte, add water only if necessary, and tighten cell caps.
3.BATTERY INSTALLATION
A.Slide battery partially into box, with positive end to inside and terminals to rear, to allow for cable installations.
B.Battery cables MUST BE SECURED TO BATTERY TERMINALS as shown in Figure 2, using the 1/4” screws, that are mounted on terminals, and lock nuts from the hardware bag.
C.Install positive (+) cable first. Place the positive
(+)terminal insulator over positive terminal and cable. Install negative
See Figure 2.
D.Slide battery into battery box and reinstall battery cover.
E.Reinstall deck support swivel and hair pin.
CABLES MUST | RED POSITIVE (+) | |
BE MOUNTED | ||
CABLE | ||
TO TERMINALS | ||
| ||
AS SHOWN |
|
POSITIVE
TERMINAL
INSULATOR
TO OUTSIDE OF
MOWER
BLACK
NEGATIVE
CABLE
FIGURE 2
INSTRUCTION No.
1